Subject: Re: [harryproa] Re: Solitarry build
From: George Kuck
Date: 11/12/2009, 10:13 AM
To: harryproa@yahoogroups.com.au
Reply-to:
harryproa@yahoogroups.com.au

 

Hello Rob,
 
You say "no sanding required"
 
Even with peel ply I would suggest you sand for added insurance of good bond, it can't hert.  Derek Kelsall has discussed this in the past and insist that you should sand even with peel ply finish.  He has had cases where the bond did not hold when stressed  with peel ply finish only.  He is quite adamant on this point and I beleive he has done test on the bonds. 

--- On Thu, 11/12/09, Rob Denney <harryproa@gmail.com> wrote:

From: Rob Denney <harryproa@gmail.com>
Subject: Re: [harryproa] Re: Solitarry build
To: harryproa@yahoogroups.com.au
Date: Thursday, November 12, 2009, 7:18 AM

 
Vinylester for the infusion, epoxy for the rest.  It is important to leave the ve for a day on the table to ensure a good finish, and then another couple of days (more if it is cold) for it to cure properly before epoxying it.  I use peel ply on all areas of the infusion that will be secondary bonded.  peel it off and glue to it, no sanding required.

rob

On Thu, Nov 12, 2009 at 9:13 PM, George Kuck <chesapeake410@ yahoo.com> wrote:
 
Hello Rob,
What type of resin are you using ?
 
Happy sailing,
George Kuck,
Chestertown, Md.
 
 



__._,_.___
.

__,_._,___