Well said Doug.

May I ask an few practical questions?

With Divinycell, how do you cut the foam? Is it mostly only knife cut? I ask because it is common to Hotwire XPS. Can one hotwire
Divinycell?

Does one ever cut Divinycell along its thickness? For example cut a 20mm sheet into two 10mm sheets.

If, as noted prior, one can get 12mm sheets cheaper than, say, 6mm sheets, could one just use heavier 12mm sheets generally?
Can you think of where one could not do this?

Thank you Doug.

Of course, if anyone has experience or thoughts on the above, please advise.

• New Members 1