| > What kind heat temp you think is needed? Electric blanket or flame? Probably something between?

| The epoxy wil soften at less than 100C/212F so more than a blanket,
| less
| than a flame. Hot air guns, or blower heaters work well.

Heat gun worked great. I put a little heat on the glass with a torch too, probably didn't need it and it popped off easy. Far less trouble than I thought it might be.

Blade cleaned glass up great. Will screw around again next week. This is amazing stuff. I was sure I had epoxied the stuff to glass permently.

Finish on the glass side was amazing. Can I get a shine like that with plastic sheet? The cheap PE plastic sheet side had a mat finish. Probably can buff or coat again to get a shine, but wonder if the proper nylon vac bag will give good finish.

Thanks again all.