Subject: Re: [harryproa] Release wax |
From: "'.' eruttan@yahoo.com [harryproa]" <harryproa@yahoogroups.com.au> |
Date: 10/22/2018, 8:01 AM |
To: harryproa@yahoogroups.com.au |
Reply-to: harryproa@yahoogroups.com.au |
| Bjorn and Erutan,
|
| Practical sailor just ran a test on mold releases, comparing
I am using Vaseline. I put a very small amount on the mold and hit it with a heat gun and it flows everywhere and stays when it cools. I end up removing some large portion of the small amount as I work it around and into the mold with paper towel. Seems to work. I am also using it on anything I want to get epoxy off easy, like fittings.
Will update if I notice any problems.
Reply via web post | • | Reply to sender | • | Reply to group | • | Start a new topic | • | Messages in this topic (15) |